Omega Owners Forum

Omega Help Area => Omega Electrical and Audio Help => Topic started by: ngrainqey on 01 March 2012, 21:23:26

Title: manual gearbox conversion wiring...
Post by: ngrainqey on 01 March 2012, 21:23:26
"Electrical

Cut off the auto selector switch connector.
 Starter inhibit
 Join the two thick Bk/R wires by soldering.
 Reverse Lights
 Separate the reverse switch wires from the donor loom and solder one side to the Bk wire (was on   pin D) solder the other side to the W/Bk wire (was on pin F)
 Lambda sensors
Plug-in the Lambda sensors, the auto loom is a bit short so move the connector fixing clips and tyrap the loom in place clear of hot bits. Tie up unused connectors and loom ends"

how d'you know which pin F or D is in the case of the reverse lights?
thanks
alex
Title: Re: manual gearbox conversion wiring...
Post by: Martian on 02 March 2012, 00:00:29
Quote from: ngrainqey on 01 March 2012, 21:23:26
"Electrical

Cut off the auto selector switch connector.
 Starter inhibit
 Join the two thick Bk/R wires by soldering.
 Reverse Lights
 Separate the reverse switch wires from the donor loom and solder one side to the Bk wire (was on   pin D) solder the other side to the W/Bk wire (was on pin F)
 Lambda sensors
Plug-in the Lambda sensors, the auto loom is a bit short so move the connector fixing clips and tyrap the loom in place clear of hot bits. Tie up unused connectors and loom ends"

how d'you know which pin F or D is in the case of the reverse lights?
thanks
alex
It won't matter what way you connect them, it's just a switch that connects the two together when reverse is selected.
Title: Re: manual gearbox conversion wiring...
Post by: 2woody on 02 March 2012, 08:38:03
teach ecu that it's now a manual
remove wires from loom
remove controller and unused contacts behind centre console
Title: Re: manual gearbox conversion wiring...
Post by: ngrainqey on 03 March 2012, 08:57:47
i thought it'd be less messing to rip ecu out and tell engine ecu its a manual, solder starter inhibitor wires together n sort pin F and D so i have the reverse lights lol, opps cruise control :P
Title: Re: manual gearbox conversion wiring...
Post by: bigtow on 17 March 2012, 22:02:46
i have just brought a y plate mv6 estate that was a 2.6 auto and now has a 3.2 manual in it the conversion was done by someone else robseymv6. i would like to retro fit cruise control what will i need or will the wiring loom still be in place and i will only need new switches and a possible visit to a tech2 ?
Title: Re: manual gearbox conversion wiring...
Post by: ngrainqey on 19 March 2012, 19:15:14
just need wires connecting between brake and clutch pedal switch  :)