Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: robson on 04 August 2012, 10:56:08

Title: breathers facelift V6
Post by: robson on 04 August 2012, 10:56:08

I am back to this topic again Is it necessary to remove the scuttle to get at the pipes involved. And is there anyone in the south east that would help and teach  with this task for a petrol allowance and payment

Title: Re: breathers facelift V6
Post by: amba on 04 August 2012, 11:12:39

If they haven,t been cleaned in a long time ..or your ownership..for extra peace of mind I would suggest removing the plenum as you can also give that a good clean whilst removed.Make sure you push rag or kitchen roll down the inlets as you don,t want to drop anything down  them.

In all honesty it is a very straight forward job and if you follow the excellent guide to the letter you will not go wrong.

I would happily offer assistance as not too far away ,however I am slightly imobile at present due to a stomach operation so if it can wait a few weeks then should be back fit and happy to assist.

Title: Re: breathers facelift V6
Post by: amba on 04 August 2012, 11:14:32

Scuttle panel can remain in place as access is fine without being removed and you may end up disturbing seal.

Title: Re: breathers facelift V6
Post by: robson on 04 August 2012, 11:34:43

Thanks Amba disturbing seal was my worry The breathers were cleaned  jan 2010 and I have done about 10,000 miles since , oil change every 3,000. my worry was an apparent lack of access but you say that is not a problem. Thanks for the offer if I take it up I could come to you if thats better.

Title: Re: breathers facelift V6
Post by: Webby the Bear on 04 August 2012, 12:33:24

i'm due to do mine either today or next weekend. could prob borrow the step daughters cam corder and film it if that wud be easier. if so just let me know...  :y

Title: Re: breathers facelift V6
Post by: TheBoy on 04 August 2012, 12:56:00

First time you do it yourself, might be easier to remove scuttle, but certainly not necessary.

Title: Re: breathers facelift V6
Post by: robson on 04 August 2012, 13:52:00

Thanks Webby That would be a great help

Title: Re: breathers facelift V6
Post by: biggriffin on 04 August 2012, 15:17:25

 i find removing scuttle just gives bit more room.

Title: Re: breathers facelift V6
Post by: Webby the Bear on 04 August 2012, 15:24:39

it defintely helps. especially as i have replaced my hose ''clamps'' for jubilee clips and need to get a small screwdriver in there.

as for the seal when i put it back i noticed there was a bit of a gap between the joins right above the disspac.  ::) so i sealed that up  :)

Title: Re: breathers facelift V6
Post by: Webby the Bear on 04 August 2012, 17:44:28

right mate, i've sourced a cam corder :)

do you want the whole job videoing or just the scuttle removal?

Title: Re: breathers facelift V6
Post by: Webby the Bear on 04 August 2012, 17:47:21

i note yours is a 2.6..... is that the DBW with droop snoop plenum? mines with throttle cable....

Title: Re: breathers facelift V6
Post by: robson on 04 August 2012, 22:37:44

As much as possible please Webby.