Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: scottambrose on 12 September 2012, 20:06:15

Title: oops
Post by: scottambrose on 12 September 2012, 20:06:15

In.cutting off my anti roll bar link that was siezed ive cut the abs sensor lead in the loom ive solderes the wires back tigether but the abs andtc light is still on

Title: Re: oops
Post by: dbug on 12 September 2012, 20:07:41

Either wires not joined correctly or dry joints

Title: Re: oops
Post by: scottambrose on 12 September 2012, 20:31:32

Will I need to reset anything

Title: Re: oops
Post by: TheBoy on 12 September 2012, 21:43:23

Quote from: devonscott on 12 September 2012, 20:31:32

Will I need to reset anything

no, should work when fixec

Title: Re: oops
Post by: scottambrose on 12 September 2012, 21:48:53

Thank god for that just my luck I cut the loom before the plug or id of just got a new sensor

Title: Re: oops
Post by: scottambrose on 13 September 2012, 08:26:05

help. i had to cut the plug off and then join the wires back up either side of the plugs but on the loom side there is a blue wire a brown wire and bare wire in the middle but on the sensor side its just a brown and a black wire no third wire. im stuck now. can anyone help i cant get the light to go out >:(

Title: Re: oops
Post by: briy2 on 13 September 2012, 08:35:45

Think the bare wire is just a shielding wire

Title: Re: oops
Post by: scottambrose on 13 September 2012, 08:43:06

so in that case then when ive joined the brown to the brown and the blue to the black the light should go off but it hasnt or do i need to drive it a bit

Title: Re: oops
Post by: scottambrose on 13 September 2012, 11:33:27

ive driven it and its still on.  >:(

Title: Re: oops
Post by: noel on 13 September 2012, 19:08:45

if there is a code showing try clearing it  :y