Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: fuelwiseno.1 on 16 September 2012, 09:36:26
-
my 2.6v6 had the oil cooler problem a few years ago and although very reliable since, i feel it is in need of a good rebuild. the car is a manual. question is--- could i fit a 3.2 onto this gearbox? if so, what donor vehicles could the engine be sourced from. i would have the new engine fully overhauled before fitting. what else would need changing? has any of you done this? thanks tom
-
Should be a straight forward engine swap :y
RobseyMV6 has done this conversion, sure others have also :-\
-
You'd probably want to change the diff ratio too.
IIRC the 3.2 will run fine on a 2.6 ECU but if you want to swap to a 3.2 one you'll need the immobiliser and key transponders to match the ECU.
-
Hi Guys,
Would it be "restricted" on the 2.6 ecu or would the differences be minimal that you would not notice?
-
Which gearbox?
Manual should already have the R28 which is tough enough to cope with the 3.2.
Auto will have the AR25 & a torque converter matched to the 2.6 V6.
The AR25 is considered a bit fragile by those who have 'chipped' their 2.5 diesel engines. Depending on your driving style you may be OK :-\ Also not sure whether there is a different gearbox map that should be loaded into the gearbox ECU :-\
-
Manual should already have the R28
OP has a 2.6 so should have the R25 fitted
-
Manual should already have the R28
OP has a 2.6 so should have the R25 fitted
R25 should be fine with a 3.2 though. It's the auto boxes where there will be problems.
-
What would the 2.6 do if it were plugged into a 3.2 ecu :-\
-
What would the 2.6 do if it were plugged into a 3.2 ecu :-\
Pretty much work as normal, I think. The ECU fuels according to MAF so the smaller engine will just draw a little less air, and a little less fuel will be delivered.