Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: jordan681 on 11 October 2012, 19:58:42
-
I there.. Can anyone give me some advise about repairing my Beloved Irmscher front bumper... some little T**T reversed inti the front of my omega at tesco and did a runner... leaving me with a X shape split in the top of my bumper.. a split washer bottle, a bent Bumper support and a damaged bonnet..
Alas I have managed to sort a bumper, bottle and a bumper support bar from here... but need help with the Bumper repair itself...
-
Fibreglass, resin and body filler mate - dependant on the extent of the damage.
A pic might help ;)
-
for an advice a piccy would be useful.. however, if you are going to use a filler buy good quality , mix at correct ratios and after application wait as recommended.. or it will suck paint and you will have to redo the job.. if possible avoid fillers..
instead I recommend good quality plastic primers+ primers , proper sanding and again applying primer.. so in case there is a fracture it will cover the surface strongly.. best is epoxy..
-
An old soldering iron to weld the split, then reinforce from behind with fibreglass/reinforced expoxy, fill and paint the front as required. :y
Used this to good effect on a couple of cars :y