Omega Owners Forum
Chat Area => General Discussion Area => Topic started by: omega3000 on 22 December 2012, 14:06:24
-
I bought and used my detail sander quite a few times without any issues , i cant get anything to work on it now , it was working fine before i put it away.. ive changed the fuse in the plug but still not working ??? Anything else i can do/check before i have to throw it away :(
-
Pull the cover off to see if you have pulled a wire out.
Voltage check with a meter before and after the switch (red / live on the switch, black / neutral on the negative) to see if the switch is knackard.
Thats about it really :)
-
:-X :-X vandal :y :y :y
-
Pull the cover off to see if you have pulled a wire out.
Voltage check with a meter before and after the switch (red / live on the switch, black / neutral on the negative) to see if the switch is knackard.
Thats about it really :)
Will do just that :y
:-X :-X vandal :y :y :y
It has served well , even sanded some of the triumph herald with it :-X ;D
-
Check the cable for cuts/nicks.
It's usually the switch, though, in my experience.
-
Pull the cover off to see if you have pulled a wire out.
Voltage check with a meter before and after the switch (red / live on the switch, black / neutral on the negative) to see if the switch is knackard.
Thats about it really :)
Will do just that :y
:-X :-X vandal :y :y :y
It has served well , even sanded some of the triumph herald with it :-X ;D
it did work hard if you sanded all the rust off a herald
-
Pull the cover off to see if you have pulled a wire out.
Voltage check with a meter before and after the switch (red / live on the switch, black / neutral on the negative) to see if the switch is knackard.
Thats about it really :)
Will do just that :y
:-X :-X vandal :y :y :y
It has served well , even sanded some of the triumph herald with it :-X ;D
it did work hard if you sanded all the rust off a herald
Only the roof , my arms gave up after that ;D