Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: PhilRich on 26 June 2013, 07:15:11
-
Is the steel multilayer exhaust manifold gasket on a 2.2 re-usable :-\
-
Personally I would change it as they are a crush type gasket.
If your stuck for time and need the car you can but try.
-
I presume you mean the gasket between manifold and cat section. I find changing the cat section takes and hour or more, and I would not want to do it all over again for the cost of a £3 gasket. One is instructed to avoid using grease or any gasket compound lest it poison the catalyst. I keep spares hanging on my garage wall.
-
i'd stick a new one on, make sure its a decent multi-layer one again though :y
-
i'd stick a new one on, make sure its a decent multi-layer one again though :y
Where do you get them from ::)
-
i'd stick a new one on, make sure its a decent multi-layer one again though :y
Where do you get them from ::)
Any good motor factors ;)
-
i'd stick a new one on, make sure its a decent multi-layer one again though :y
Where do you get them from ::)
Any good motor factors ;)
Aye thats ok then , think mines beyond rejuvenation , done well for 14 yrs :-\
-
i'd stick a new one on, make sure its a decent multi-layer one again though :y
Where do you get them from ::)
Any good motor factors ;)
what not vx ;D ;D ;D