Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: Shandyman on 26 June 2013, 20:24:07

Title: how to setup throttle adaptations on a 2001 2.2 petrol
Post by: Shandyman on 26 June 2013, 20:24:07

looked on Op COM and i cant get it to work
have also tried bosch KTS,  snap on solus plus and VCDS.......nowt works

Title: Re: how to setup throttle adaptations on a 2001 2.2 petrol
Post by: RobG on 26 June 2013, 20:51:49

What exactly are you trying to achieve :-\

Title: Re: how to setup throttle adaptations on a 2001 2.2 petrol
Post by: chrisgixer on 26 June 2013, 23:31:03

adaptions mean just that, they adapt, to your driving style or whatever.

I doubt its something that can be fiddled with...?

Title: Re: how to setup throttle adaptations on a 2001 2.2 petrol
Post by: Shandyman on 27 June 2013, 00:44:40

Ok .,roller disintegratred took belt out, valves and guides ...all have been replaced.the problem I've got is that it that it starts but cannot clear or reset throttle adaptionsp

Title: Re: how to setup throttle adaptations on a 2001 2.2 petrol
Post by: Kevin Wood on 27 June 2013, 11:02:19

There shouldn't be any need to touch anything in the ECU following a rebuild.

You can reset block learning and, on some ECUs, idle valve learning but I'm not even sure if that would be relevant to a drive-by-wire engine. In any case, these are only required for diagnostic purposes in specific circumstances and not following a cam belt failure.

Please let us know what symptoms you have which might indicate a problem (you say it starts - does it drive ok? any trouble codes in the engine ECU?) and we'll do our best to help.

Title: Re: how to setup throttle adaptations on a 2001 2.2 petrol
Post by: albitz on 27 June 2013, 14:50:24

If it does need doing I wouldn't want to do it using a Chinese O---m device either.Way too risky imo.  ;)

Title: Re: how to setup throttle adaptations on a 2001 2.2 petrol
Post by: Shandyman on 12 July 2013, 19:48:01

Faults I have are throttle position sensor and adaption faults.engine starts and runs fine but won't rev....!after 15-20 mins cuts out....cannot get throttle actuator to operate At all even though it has been changed

Title: Re: how to setup throttle adaptations on a 2001 2.2 petrol
Post by: RobG on 12 July 2013, 19:51:03

Anything be done to throttle body?

Title: Re: how to setup throttle adaptations on a 2001 2.2 petrol
Post by: Andy H on 12 July 2013, 20:42:49

"Throttle adaptation" is term I have seen used on VW forums. I don't think it has any relevance to Vauxhalls.

If the software is using the term "throttle adaptation" then it does tend to reinforce concerns that the software isn't fit for purpose :-\

Most likely cause is damage to the wiring or throttle body while the engine was out (or maybe someone forgot to plug the connector into the throttle body ::) you wouldn't be the first..........)

Title: Re: how to setup throttle adaptations on a 2001 2.2 petrol
Post by: Vitaliy on 12 July 2013, 21:28:44

Hi
its probably a stupid suggestion - but have you by any chance used wrong connector!!! had same trouble when was assembling my engine long time ago and  PFL omegas with square plugs use same plug on Camshaft positioning and throttle positioning sensors. ECU would not always store CPS error but would not run above 4000rpm.