Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: Toledodude1973 on 10 July 2013, 20:58:01

Title: plenum seals
Post by: Toledodude1973 on 10 July 2013, 20:58:01

I want to clean breathers out , so ordered new seals from dealers but they dont seem correct ,is there one that goes over the "top hat" type bit? i got the part no.s from a guide on the forum,  thanks

Title: Re: plenum seals
Post by: dbug on 10 July 2013, 21:34:42

Yep - Breather bridge to plenum seal 1 off required - 90467543 (top hat o-ring) :y

Title: Re: plenum seals
Post by: Toledodude1973 on 10 July 2013, 21:40:46

Thanks for reply , thats the part no. i've got , its come as a flat rubber washer with a small 5mm ish hole in it, does that seem right?

Title: Re: plenum seals
Post by: dbug on 10 July 2013, 21:53:59

Quote from: Toledodude1973 on 10 July 2013, 21:40:46

Thanks for reply , thats the part no. i've got , its come as a flat rubber washer with a small 5mm ish hole in it, does that seem right?

No, but i've had the correct "top hat" o-ring supplied against that part number in the past ;)

Post up a pic of what you've got.

Title: Re: plenum seals
Post by: Toledodude1973 on 11 July 2013, 19:47:23

Thanks dbug i have trouble posting pics , the seal i've got is not right , i'll get vaux part dept to show me on parts info to make sure it looks something like a top hat before ordering, the one they ordered last time is just like a standard washer but in fibre