Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: glennyboy on 31 July 2013, 11:38:17
-
Hi is there anyone near me that can do a inner osf track rod arm funds are not great but 100-150 quoted is beyond me if soneone could that would be great thanks im still using car but steering all over the placethanks
-
Sorry, too far for me, but TRE is about £30 for GM, or half that for pattern (I'd go GM), and about 0-15mins to change. Even adding in tracking (which I doubt was on the quote), "£100-£150" sounds steep :o
-
you may be better off purchasing the whole arm complete with both track rod ends, if one end has gone then the other end is probably not far behind. a ball joint splitter, a 17/19mm spanner, jack, axle stand and a 2.5 pound hammer should still be on the right side of £150.00. some times its easier to go DIY !