Omega Owners Forum

Omega Help Area => Omega Electrical and Audio Help => Topic started by: frenchtony on 22 October 2013, 21:50:09

Title: NCDC 2013 Cartridge won't stay in
Post by: frenchtony on 22 October 2013, 21:50:09

Hi
all was well with the cd stacker unit, then it stopped reading the discs, I ejected the cartridge, checked the discs, all look ok but now the cartridge wont stay in, it just springs back out immediately, no clicks or anything.

Anyone with any ideas?

Title: Re: NCDC 2013 Cartridge won't stay in
Post by: TheBoy on 23 October 2013, 19:21:45

I'd say either mech is bent, or come mechanically out of sync.

Either way, a fiddly, tedious and often unsuccessful repair :(

Title: Re: NCDC 2013 Cartridge won't stay in
Post by: radelet on 15 December 2013, 23:28:34

I have same same problem ! My ncdc2015 played cd fine, i wanted to change disk in magazin it ejected fine, i put new cd in magazin and when I put it back in the unit dont wont to take it :( whot shall I do ?

Title: Re: NCDC 2013 Cartridge won't stay in
Post by: TheBoy on 16 December 2013, 17:41:36

Quote from: radelet on 15 December 2013, 23:28:34

I have same same problem ! My ncdc2015 played cd fine, i wanted to change disk in magazin it ejected fine, i put new cd in magazin and when I put it back in the unit dont wont to take it :( whot shall I do ?

There is a guide in our Maintenence Guides section for swapping over the CDC3. If the mech is bent, or out of sync, I'd acquire a known good CDC3 and swap it over. Use your existing horizontal CDC3 I/O board, as its security coded.

Title: Re: NCDC 2013 Cartridge won't stay in
Post by: radelet on 19 December 2013, 14:17:03

I open my unit and fix mechanisam, now its working again  :y