Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: husky12 on 12 December 2013, 10:45:37
-
2.5 v6 temperature hand in dash dosnt work, seems to sowrk the very odd time like if you were on a hill?
-
2.5 v6 temperature hand in dash dosnt work, seems to sowrk the very odd time like if you were on a hill?
Check the connection on the sensor ..... single terminal sensor right at the back of the engine - blue wire (the other sensor 'talks' to the engine ;)) it might just need crimping a little with pliers to tighten the connector
-
If it works when the engine is working hard its more likely to be a stuck open thermostat :y
-
If it works when the engine is working hard its more likely to be a stuck open thermostat :y
but surely you'd expect some movement of the dial :-\
-
If it works when the engine is working hard its more likely to be a stuck open thermostat :y
but surely you'd expect some movement of the dial :-\
Op did say it works sometimes like when on a hill :y
-
If it works when the engine is working hard its more likely to be a stuck open thermostat :y
but surely you'd expect some movement of the dial :-\
Op did say it works sometimes like when on a hill :y
Could be the movement of the engine making a better contact ...... 8) 8) ;)
-
i have the image in my head of wat that terminal looks like, but has any one a image just to be sure?
-
i have the image in my head of wat that terminal looks like, but has any one a image just to be sure?
It's like a drawing pin head .... round & flat ;)
It's the sensor with nothing connected to it. The wire that goes to it is the blue wire in the black sleeve lurking in the back ground
:y
(http://images.omegaowners.com/images/guides/v6_cts/DSC03043_zps6d5d5f49.jpg)
-
was thinking that. keept putting it on but wud come off again. just needed crimpoed. thanks for all the help ;D