Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: RekordE on 22 July 2014, 11:34:33

Title: AR35 in limp mode, code 83
Post by: RekordE on 22 July 2014, 11:34:33

My car stood still over the weekend and decided to take a ride. Did`nt get far before the trans went into limp mode. I can drive it manually with the lever but with each gear change a clonk follows. So I did the paper clip test and got code 83 TORQUE CONTROL VOLTAGE LOW http://workshop-manuals.com/vauxhall/omega-b/k__clutch_and_transmission/automatic_transmission_rear_wheel_drive/automatic_transmission_ar_25/35/diagnostic_information_and_procedures/diagnostic_procedures/f2_trouble_codes_trouble_code_83_torque_control_voltage_low/ (http://workshop-manuals.com/vauxhall/omega-b/k__clutch_and_transmission/automatic_transmission_rear_wheel_drive/automatic_transmission_ar_25/35/diagnostic_information_and_procedures/diagnostic_procedures/f2_trouble_codes_trouble_code_83_torque_control_voltage_low/)

Gearbox has run about 150 000km and had new oil and filter about a month ago. Engine is a C30SE with AR35.

I need some tip to what to look for, been searhing around but little info on the actual problem.

Title: Re: AR35 in limp mode, code 83
Post by: Shackeng on 24 July 2014, 12:36:12

I tried to find the Test Code 35, but it only seems to go up to 34!. Hopefully someone knowledgeable will advise. :y

Title: Re: AR35 in limp mode, code 83
Post by: RekordE on 24 July 2014, 15:31:18

Quote from: Shackeng on 24 July 2014, 12:36:12

I tried to find the Test Code 35, but it only seems to go up to 34!. Hopefully someone knowledgeable will advise. :y

After a quick searh of F0: DATA LIST - Test Step 35 TORQUE CONTROL, this come up. http://workshop-manuals.com/vauxhall/omega-b/k__clutch_and_transmission/automatic_transmission_rear_wheel_drive/automatic_transmission_ar_25/35/torque_converter/diagnostic_information_and_procedures/diagnostic_procedures/f0data_list_test_step_35_torque_control/

It ssems there is a way to do this test after all.