Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: Steve B on 22 February 2015, 21:21:57

Title: Engine ecu
Post by: Steve B on 22 February 2015, 21:21:57
What i want to do is disconnect the battery, Then i want to unplug the engine ECU and have the plug/loom end in my hand to get a test meter on the pins....

Can i do this if so  How  :y  TIA
Title: Re: Engine ecu
Post by: Doctor Gollum on 22 February 2015, 21:25:45
Yes. Loosen nattery clamp. Turn ignotion on. Then off, from which point you have 15 seconds to comply remove battery clamp completely without setting off the alarm.

Then remove fuse cover near battery. Unplug ecu. Seempleses. :)
Title: Re: Engine ecu
Post by: Andy B on 22 February 2015, 21:27:59
Yes. Loosen nattery clamp. Turn ignotion on.  ....

same with the battery clamp & ignition ...............  ::)
Title: Re: Engine ecu
Post by: Doctor Gollum on 22 February 2015, 21:30:47
Yes. Loosen nattery clamp. Turn ignotion on.  ....

same with the battery clamp & ignition ...............  ::)

Flattery doesn't get you very far. Does it, Beeses. ;D
Title: Re: Engine ecu
Post by: Steve B on 22 February 2015, 21:32:42
next question  :y  Are the pin numbers marked
Title: Re: Engine ecu
Post by: Doctor Gollum on 22 February 2015, 21:34:08
Yes. Iirc the numbers are moulded into the plug "lid"

You have any codes needed for radio etc?

And know how to reset sunroof and one touch windows etc.
Title: Re: Engine ecu
Post by: Steve B on 22 February 2015, 21:44:02
Yes. Iirc the numbers are moulded into the plug "lid"

You have any codes needed for radio etc?

And know how to reset sunroof and one touch windows etc.
Yes got car pass & its hold down button i think for windows  ...No sunroof  :y
Title: Re: Engine ecu
Post by: Doctor Gollum on 22 February 2015, 21:45:37
Very wise.  :y