Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: EMD on 20 July 2015, 09:39:31
-
Is the parcel shelf a pain to remove :-\ Think i mite need to remove it
for access for the window tint but not sure :-\
-
Can't remember the specifics, but I once faffed for a very long time accessing the amp, but another two or three screws would have brought it out no trouble. Back seat side sections off (carefully!, they don't just 'pull off') accesses a screw underneath each, then fold the backrests down, remove them, then I think another couple laid on your back in the boot, and you're there.
If I'm wrong, and there's more screws, then there's not much more to it than that, anyway :y
-
Thanks dbg , yes i was wondering where they hid the screws
for the side bits . I shall have to investigate more :y
-
If memory serves (it rarely does :D) lift the rear seat squab, and yo can acess a screw/clip/fitting, which then allows you to lift up then pull away the rear seat side bits.
Last time I did it the Spice Girls were in the charts so a while ago. :y
-
http://www.omegaowners.com/forum/index.php?PHPSESSID=j0jrnk82sm619dn0qtv38rogk6&topic=90506.0
-
That's the one
RobG's a good'n :y
-
Hmm , this limo tint aint easy :( Thanks for the link but i think ill pass on taking all that lot out :'( Ill just work around it best as possible :(
-
The couple of window tinters I've spoken to regarding omega's, hate doing them because of the curve in the rear screen, and how it slopes,restricting access.
-
on the two i have had done they did it with the shelf in place and it looked great,,no problem at all :y
-
The couple of window tinters I've spoken to regarding omega's, hate doing them because of the curve in the rear screen, and how it slopes,restricting access.
Even a curve on the side rear window :( It dont look too bad , the rear i will heat shrink on the outside first this time ::) Its all about learning :-[