Omega Owners Forum
Omega Help Area => Omega Electrical and Audio Help => Topic started by: kwhite@fsmail.net on 24 January 2017, 17:10:17
-
Hello,
I have changed my CCR2006 for another (2nd hand) unit due to a stuck CD cartridge. When installed the middle line on the display (MIT?) went blank. Initially the same happened when I re-inserted the old unit but after reading previous topics I removed then replaced fuse 12 and sure enough "Safe" appeared in the display.
I therefore put the new unit back in and tried the same but no joy. Whatever I try the middle line remains blank. I am happy the display is OK as it shows the date when the radio is switched off - it goes blank once switched on. I have checked the pins in the back of the unit and they appear fine. The unit itself lights up so I know it is getting power.
I see from previous topics that others have had the same problem but I can't seem to find a cure among the responses.
Any suggestions?
Thanks in anticipation.
Kev
-
Prob set for wrong display type. Is it 2 and 4 when turning on to toggle between the 3 modes?
-
It should still light up the middle section and request a code, irrespective of teh display settings, and if it goes blank after code entered, or code remains visible, then the display needs to be configured for either 8 or 10 digit type - Usually done by holding a couple of buttons as you switch on - 2 & 4 or 3 & 5 are the favorites - if you get nothing at all on the middle section, then I suspect you may have another fault that needs investigating
-
Apologies for my tardiness (wasn't getting notifications).
Appears this is a loose connection. The display line has come back but sometimes disappears again.
I give the unit a bit of a shove and it seems to re-connect.
I'll live with it. :(
-
Hello,
I have changed my CCR2006 for another (2nd hand) unit due to a stuck CD cartridge. When installed the middle line on the display (MIT?) went blank. Initially the same happened when I re-inserted the old unit but after reading previous topics I removed then replaced fuse 12 and sure enough "Safe" appeared in the display.
I therefore put the new unit back in and tried the same but no joy. Whatever I try the middle line remains blank. I am happy the display is OK as it shows the date when the radio is switched off - it goes blank once switched on. I have checked the pins in the back of the unit and they appear fine. The unit itself lights up so I know it is getting power.
I see from previous topics that others have had the same problem but I can't seem to find a cure among the responses.
Any suggestions?
Thanks in anticipation.
Kev
are both units in safe mode now . I live in Clifton & I have a ccr 2006 with the code that I am willing to let you try. without knowing my immediate guess its done what mine once did because I tried the wrong code too many times.
-
Kind off you to offer but what I did was to take the new CD player out of the unit I bought, placed it into my old head unit and then re-installed it. Still have the occasional problem where the middle line of the display is blank but a firm shove usually does the trick.
Now have a dismantled CD unit (so I could rescue the old magazine and CDs) and an otherwise possibly good head unit spare.
At least I got there in the end but I strongly suspect it is just the connections that the unit slides into not being 100%.
Ho hum.