Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: laney101 on 23 May 2017, 07:06:20
-
quickest way to get a thermostat link pipe v6 need one asap located liverpool
might aswell fit new thermostat housing while there if can get one too
-
Thermostats can be got from motor factors or main stealer.Transfer pipe is I think stealer only and should come with two rubber "O" rings which you'll need.
-
Just a point to mention.The flanges on some thermostat housings are thinner than the original,this is no big problem in itself.However if you have a "thin flange"type but irginal bolts these can "bottom out" while not holding the housing down tightly.So check new housing against the one you remove if it's thinner then a]get shorter bolts b]cut down the bolts you have or c]place washers below bolt heads to make up the difference.Hope that makes sense to you.
-
I just replaced original thermostat housing with a first line one and flanges exactly same thickness so no need to apply washers or shorten thread on bolt
-
baza i got a thermo from GM and your spot on flange was thinner so after advice on here i duly cut the bolts down :y
-
hmm didnt buy from gm as even with trade club was nearly 50 quid for housing .. bought first line housing came with a standard stat for 32 quid, but mine was same thickness as original gm part of car