Omega Owners Forum
Newbie Area => Newbie Welcome Area => Topic started by: Eliteinhpool on 13 April 2007, 17:25:38
-
just thought id say hello. im shaun live in hartlepool and drive an R- reg elite 3.0 car is great but had a few problems while owning it firstly overheating but was cured by new thermostat and now last night non starting but reading your forums and trying out the paper clip test i now pin pointed it down to the maf, unplug it it runs plug it in and it cuts out and wont start, being quoted £45 for the part so hopefully back on the road tommorrow. so thankyou for all the advice. :y
-
Hello & welcome :)
-
Hi and welcome to our Forum :y
-
Hello Shaun and welcome to the site. I assume MAF is used or non-VX as they can cost double that for original unit. Hope it fixes the problem - if not post in the General Help for ....well....help. :)
-
Welcome to the forum :)
-
just thought id say hello. im shaun live in hartlepool and drive an R- reg elite 3.0 car is great but had a few problems while owning it firstly overheating but was cured by new thermostat and now last night non starting but reading your forums and trying out the paper clip test i now pin pointed it down to the maf, unplug it it runs plug it in and it cuts out and wont start, being quoted £45 for the part so hopefully back on the road tommorrow. so thankyou for all the advice. :y
:)Hope it works.
-
A warm welcome to the forum, Dude! 8-) :y
-
Hello & welcome :y
8-)
DaveL
-
Welcome .. enjoy the board :y
-
Hi Shaun and welcome ;)
-
Welcome to the site :y
-
Hello and welcome to our forum :y
-
Hi Shaun and welcome