Omega Owners Forum
Newbie Area => Newbie Welcome Area => Topic started by: katiecuppa on 19 September 2009, 11:53:11
-
I have just registered on this site. I have found your site very useful from the outside! I have a '97 2.5 v6 estate that is sick. It has the classic problem of when hot it kangaroos and cuts out. Prior to this happening the temp guage drops to 0 and the rev counter flips all over the place. If you allow the engine to cool it will start as normal. The coil pack,cam sensor,crank sensor have all bee replaced by previous owner. The RAC have plugged it in and the fault code is 31. Any ideas, a woman in distress!!!! :'(
-
Hello Katie and welcome to OOF.
Post your problems in the General Help Section of the forum, where you're sure to have all the advice you need to sort out the problems with your car
Cheers
Ziad :y
-
Welcome, Fault code 31 No Engine RPM Signal,but do post in the general help section, as you will get more advise :y
-
Hello and welcome to the Forum.
:y
-
Welcome to the forum!! :y
-
Hello Katie and a very warm welcome to yet another female member! :y :y
-
Hello and Welcome,
code 31 is normal if the engine is not running. Nothing to worry about :y
Post your problrm in thr general help and we can see if we can solve it ;)
-
Welcome to OOF Katie :y
-
Hey there "women in distress". Welcome to the OOF :) :y
-
Hi Katie and welcome to the forum :)
-
Hi, welcome to the forum. :)
-
welcome welcome to oof
and a hello from plymouth devon too :y.
-
Welcome to OOF :y
-
welcome to OOF :y
-
Welcome along KC :y :y
-
Hi Katie & welcome :y
-
hi k t welcome to the forum :y
-
Hi, welcome to the forum. :y
-
welcome along, hope you get it sorted ;)
-
"Hello" and Welcome :)
-
Hi Katie, welcome to OOF :y
-
hello
-
Hi and welcome to the forum :y
-
Hello KC alate but warm hiya :y