Omega Owners Forum
Newbie Area => Newbie Welcome Area => Topic started by: bodach on 09 May 2010, 16:18:11
-
Any advice gratefully recieved!
It started with misfiring when the car was cold, engine warning light coming on, hand held codes = O2 sensor fault which cleared. Then the misfire got worse, I cleaned the throttle assembly, & associated breather pipework.
When I refitted the throttle assembly initially there was control, then a backfire and steady revs @ 12000rpm.
The hand held came up with throttle minimum position not found, service required on throttle assembly & no MAF flow.
When I reset the codes there is throttle control, if I switch off the engine its back to 12000 revs.
I have trawled the forum for similar problems there are a few with various solutions, change MAF, O2 sensor.
My fear is that the throttle position sensor has failed when I cleaned the assembly 240 on ebay for a replacement.
The fact it resets could be 2 things (I think)
1 the reset overrides the logic in the ECU and allows a start.
2 the ECU has lost the signal from the TPS & requires to be reloaded, is this possible? maybe a dealer job?
Any advice welcome, thanks in advance.
-
Hello and a warm welcome to you! :y
For a far better response to your query please post it under the Omega General Help section ;) ;)
-
Welcome bud! :y
-
Welcome to OOF mate :y
Impressed your 2.2 revs to 12000 rpm :o
-
Welcome along B :y :y
-
Hi & Welcome :y
-
How do matey. Welcome along :y :y
As Lizzie says :y
-
WELCOME :y
-
Hello & Welcome :y
-
hi and welcome :y
-
Hi, welcome to the forum. :y
-
Hello,welcome to the Forum :y
-
Welcome to OOF. :y
-
Hiya welcome :y
-
hi and welcome to OOF :y
-
Hello and welcome to the Forum. :y :y