Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Bernard on 30 May 2007, 21:22:36
-
When fitting New sensor Best to leave old cable in place and cut both ends of tidy.
As will been seen in previouse post i tried to pull old cable out but this had been tiewrapped to Engine Tempreture Gauge and Coolant Switch to ECU leads which then became Disconnected.
Unfortuneately the only way to reconnect these is to remove the Inlet Manifold and pay Mr Vauxhall Lots of Money for New Seals !!!! :( :( :( :(
Hope this post saves others the Hassle i experianced :) ;)