Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: ffcgary1 on 22 June 2007, 18:11:15
-
Is it poss to fit 3.2cams into a 2.5 engine seeing as you can fit 3.0 into 2.5 v6's.just mulling ideas over in my brain cell, ;D ;D
-
No...
3.2 cams won't even fit in a 3.0 engine.
The 2.5 and 3.0 are basically the same lump with different sized heads and a few other bits and bobs. ::)
3.2 is quite different...
You want a set of 3.0 cams. Expect to pay £100+ for a set, and yes, you do need all 4!
-
No...
3.2 cams won't even fit in a 3.0 engine.
Yes they will they are the same head design.....
Not sure if they are the same cam shafts.
There is not a great deal of difference between the 3.0 and 3.2 engine mechnics...
-
So what do you fit in a 2.6?
-
No...
3.2 cams won't even fit in a 3.0 engine.
Yes they will they are the same head design.....
Not sure if they are the same cam shafts.
There is not a great deal of difference between the 3.0 and 3.2 engine mechnics...
Hmmm...
When I looked at this I found the heads were actually slightly different with altered profiling on the cams.... but I will defer to your greater knowledge. :)
-
rumour has it that EPC shows the inlet cam is the same for 3.0 and 3.2's - but the exhaust cam has a different part number for the 3.2 ... ::)
-
so will 3.2 cams fit 2.6?
-
Me thinks that this conversion needs further investigation.How about 3.2 inlet,and 3.0 ex in a 2.5 motor. :D