Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: bill_connor on 26 December 2007, 15:55:54
-
has any one removed omega glove box for fitting of glove box handle
-
yes mate many times ! right pain !! ;D
-
yes mate many times ! right pain !! ;D
Give him a clue then Markey :o
-
Glove box removal will be this morning's job, I need to find out why I have no cabin blower.
From memory, passengers side airbag has to loosened and raised to give access. Mr Haines also says there are four screws securing the box, I recall a hidden one under the trim at the far left of the dash.
Will know for sure in an hour or so.
-
yes mate many times ! right pain !! ;D
Give him a clue then Markey :o
he didnt ask for instrutions just if any one had ;D ;D
quite easy just make sure you undo all screws you have to remove the three bolts holding the airbag cover then there are two screws under there and two lower down then take side panel of end of dash there are two screws there as well once all the screws are out gently pull forward and dissconnect the plugs from switch and lamp !! then you have to separate the lid from the box two pins in hinges need to be pushed out and dissconect the ram then wiggle the lid out then remove all the screws you can see in lid and remember to operate the catch or you will break the ends off ! then remove the cover then you can see the mech remove that then repair and reassemble !! ;) ;)