Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: JamesV6CDX on 25 January 2008, 23:39:08

Title: Camshaft location
Post by: JamesV6CDX on 25 January 2008, 23:39:08

On a 3.0 when I put it together -

I presume, that I put any cam marked "G" in the inlet, and any cam marked "A" in the Exhaust?

Title: Re: Camshaft location
Post by: Kevin Wood on 25 January 2008, 23:42:37

They're the same between banks, IIRC. Extra length on the passenger side is taken up by the different pulley.

Kevin

Title: Re: Camshaft location
Post by: JamesV6CDX on 26 January 2008, 00:08:14

Quote

They're the same between banks, IIRC. Extra length on the passenger side is taken up by the different pulley.

Kevin

Indeed it is :)

I just wondered if there was any identification difference between the banks, from the factory.

Where did you get all your V6 knowledge Kev? Have you stripped many of these things?

I've rebuilt a few at the top end, but I'm still learning many little things! :)

Title: Re: Camshaft location
Post by: Kevin Wood on 26 January 2008, 00:22:27

Just one V6. ClarCE's 3.0 cam upgrade. That was a fun day. :y

I'm pretty sure the cams are the same regardless of bank.

Kevin

Title: Re: Camshaft location
Post by: MutantCav on 26 January 2008, 08:49:33

Yes mate, inlet (middle 2 cams) will be the G cams and the exhaust cams are the A's

Title: Re: Camshaft location
Post by: Marks DTM Calib on 26 January 2008, 09:20:27

All the info is in the maintenance section.....