Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: tunnie on 24 February 2008, 17:46:48
-
top pipe into the matrix, very hot (too hot to hold)
bottom pipe cold/luke warm.
(on the V6)
-
Check the vac and vac hoses....
-
Check the vac and vac hoses....
TB removed the vac hose on the HBV as a test, made no difference.
The other vacs i should check are? :-/
-
With vac pipe off the HBV you should get heat
Also try sucking on the pipe that goes to the hbv and then see if you get heat - or if you can constantly suck, there may be a vacc leak in the cabin not letting the heat in..
-
With vac pipe off the HBV you should get heat
Also try sucking on the pipe that goes to the hbv and then see if you get heat - or if you can constantly suck, there may be a vacc leak in the cabin not letting the heat in..
The large pipe into the matrix? gunna need a lot of suck! ;D
-
With vac pipe off the HBV you should get heat
Also try sucking on the pipe that goes to the hbv and then see if you get heat - or if you can constantly suck, there may be a vacc leak in the cabin not letting the heat in..
The large pipe into the matrix? gunna need a lot of suck! ;D
No you daftie.... suck on the vac pipe that usually goes on top of the HBV :D
-
With vac pipe off the HBV you should get heat
Also try sucking on the pipe that goes to the hbv and then see if you get heat - or if you can constantly suck, there may be a vacc leak in the cabin not letting the heat in..
The large pipe into the matrix? gunna need a lot of suck! ;D
No you daftie.... suck on the vac pipe that usually goes on top of the HBV :D
Got ya
-
take both pipes off and flush both ways with hose pipe bud did mine last week lovly warm heater again !! do it a good few times till water runs clear !! :y