Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: Elite Pete on 04 March 2008, 10:48:04

Title: Elite leather
Post by: Elite Pete on 04 March 2008, 10:48:04

I am fitting MV6 leather sport seats in my Elite and putting the Elite seats back in the doner MV6, the sport seats into the Elite are straight forward but has anyone fitted Elite leather in there Omega and what wiring had to be done.

TIA :y

Title: Re: Elite leather
Post by: Marks DTM Calib on 04 March 2008, 11:52:08

Ok, well you should already have all the MV6 vehicle connectors populated and then be lacking the large X50 connector for the memory function on the car loom.

So, look at the large X50 connector on the seats loom and connect pin 1 (red 2.5mm) to the large red wire for the seat height adjustment.

You also need to connect pin 2 (black) of the memory loom, idealy this should go to an ignition swithced feed but, you could also connect this to the large red for the seat height adjustment.

The last one is the 0V connection on pin 3 (brown), again connect this to the brown wire on the height adjustment.

Title: Re: Elite leather
Post by: Elite Pete on 04 March 2008, 11:54:52

Brilliant,

Cheers Mark :y

Title: Re: Elite leather
Post by: The Doctor on 04 March 2008, 17:42:28

Is this directly related to why my MV6 with Elite leather in it doesnt let me adjust the drivers seat. The passengers electric seat adjusts, but the drivers is stone dead.

Title: Re: Elite leather
Post by: Marks DTM Calib on 04 March 2008, 19:05:47

Quote

Is this directly related to why my MV6 with Elite leather in it doesnt let me adjust the drivers seat. The passengers electric seat adjusts, but the drivers is stone dead.

Quite possibly, the wires described above are to power the seat controller....