Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: marcus on 07 March 2008, 13:01:33

Title: door removal
Post by: marcus on 07 March 2008, 13:01:33

hi
need to replace both doors crushed by a bus - can see the two roll pins holding on the doors but is there any special way or tool used for getting these out as driving them out from the top looks difficult to get at?
as usual haynes manual pretty useless in this respect - is there a better manual available?

Title: Re: door removal
Post by: davlad22 on 07 March 2008, 13:10:15

Yes, you can buy a proper pin puller. The tool is prone to breaking though if they've been there a long time.

Remember to support the door with a jack.

Title: Re: door removal
Post by: davlad22 on 07 March 2008, 13:12:51

http://cgi.ebay.co.uk/BERGEN-TOOLS-DOOR-HINGE-PIN-REMOVER-SET_W0QQitemZ140212171979QQihZ004QQcategoryZ30917QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

Title: Re: door removal
Post by: Markie on 07 March 2008, 13:13:32

a drift will also do the job - with the aid of a pair of pliars  :y

Title: Re: door removal
Post by: Andy B on 07 March 2008, 13:17:27

Quote

hi
need to replace both doors crushed by a bus - can see the two roll pins holding on the doors but is there any special way or tool used for getting these out as driving them out from the top looks difficult to get at?
as usual haynes manual pretty useless in this respect - is there a better manual available?

Something like this (http://www.tooled-up.com/Product.asp?PID=29022&Referrer=Froogle)




 (http://img3013.photobox.co.uk/761661248bd3117e24d6059e64bb53b3f61d77604896641cb0e5b3e5692c0f2759a968b8.jpg)Or I made this from tool steel