Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Johnwa on 13 March 2008, 14:31:17
-
Hello Forum.
I've a '97 2.0 16v Gls Estate and the heater motor won't operate on the bottom three switch settings - although it will work when on the top setting. The problem only started this week - up until then all worked ok.
I get the same situation when using the air con or air recycle mode.
Before I go and do any unneccessary work, I would be grateful if you chaps could point me in a direction that could save me time.
All responses would be very much appreciated.
Thanks.
Johnwa.
-
Check your scuttle drain first - is it ful of water - see FAQ
-
Done - there was a bit of debris in there, but no water - all cleared out, but still no go. Could this be a relay fault?
Ta
Johnwa
-
Is there perhaps a fault in the resistance-pack or it`s connector?
I think it lives in the draughty-bit somewhere in the airducting near the heater-matrix. ;)
-
Yeh, fan speed resistor is favourite which lives behind the glove box in the air trunking to the right of the fan