Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Martin_1962 on 28 March 2008, 19:29:35
-
PSI BAR whatever, need to see if my bodge will work
-
at a guess I would say about 30-40 psi, but I am sure someone with more scientific knowledge will give you a better answer soon :y
-
It's not too high. Perhaps 10 or 12 PSI. I forget what the expansion tank cap is rated at but it may be stamped on it. That's the ultimate limit to the pressurisation.
Kevin
-
12 ish Psi....
-
12 ish Psi....
Will alradite hold a copper pipe glued into a nylon pipe?
I hope so as I need to hunt for a new T piece
-
12 ish Psi....
Will alradite hold a copper pipe glued into a nylon pipe?
I hope so as I need to hunt for a new T piece
Chose the right araldite, it has a habit of softening when warm and roughen it all up well first so it gets a good key.
-
12 ish Psi....
Will alradite hold a copper pipe glued into a nylon pipe?
I hope so as I need to hunt for a new T piece
Chose the right araldite, it has a habit of softening when warm and roughen it all up well first so it gets a good key.
Couldn't find slow set and rapid didn't work - have some 2nd hand tees on their way!
-
Hi,
Some while back I made up a tee piece with Schreader Tyre valve in it so I could fit in the system to pressurise it cold to check for leaks.
I found the header tank pressure cap started to release at just over 13 PSI.
HTH
Roger