Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: iggy21uk on 29 April 2008, 10:58:37

Title: Accelerator cable info needed
Post by: iggy21uk on 29 April 2008, 10:58:37

Just done my cam cover gaskets
No fault codes, will not very well accelerate.
the accelerator peddle seems lower down

Think I may have put the clip on the cable outer in the wrong place
Can  any one tell me which side of the rubber grommet it goes please?

Title: Re: Accelerator cable info needed
Post by: hotel21 on 29 April 2008, 11:13:21

This help?

http://images.omegaowners.com/images/guides/prefacelift_cruise_retrofit/cruisethrottlebodyconnection.jpg

http://images.omegaowners.com/images/guides/prefacelift_cruise_retrofit/cruisegenerallayout.jpg

Title: Re: Accelerator cable info needed
Post by: TheBoy on 29 April 2008, 11:27:18

Behind.  Set it so the cable has only small slack in it.

Title: Re: Accelerator cable info needed
Post by: iggy21uk on 29 April 2008, 11:31:08

Yep, I've put it the wrong side.
Will move it when stops raining.

Thanks

Title: Re: Accelerator cable info needed
Post by: iggy21uk on 30 April 2008, 03:09:33

Thanks . Back to normal fingers crossed. Just hope seals don't leak.

Like to know how to remove cable tray -  it would have  been a lot easier if knew how ?

Title: Re: Accelerator cable info needed
Post by: TheBoy on 30 April 2008, 19:35:12

Quote

Thanks . Back to normal fingers crossed. Just hope seals don't leak.

Like to know how to remove cable tray -  it would have  been a lot easier if knew how ?

it unclips apart...

Title: Re: Accelerator cable info needed
Post by: Entwood on 30 April 2008, 19:48:42

Its an absolute *** ... use a very small screwdriver, and be gentle, work from one end around the edge .. takes a while .. but it is worth doing if changing the cam cover gaskets ... I know .. the hard way !!!

Title: Re: Accelerator cable info needed
Post by: iggy21uk on 30 April 2008, 23:51:35

Quote

Its an absolute *** ... use a very small screwdriver, and be gentle, work from one end around the edge .. takes a while .. but it is worth doing if changing the cam cover gaskets ... I know .. the hard way !!!

Your right?