Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: mega3.0v6 on 16 May 2008, 10:46:15

Title: 3.0 v6
Post by: mega3.0v6 on 16 May 2008, 10:46:15

Hi all i got a little problem with my car when the car gets warm it starts to like missfire between 1.5k 2k revs. after that it is fine goes up the full range of revs. I have changed leads and spark plugs had it plugged into tech2 by a vauxhall mech with no faults found. But if i flip the throttle b4 pulling away it is sort of ok so could it be the throttle position sensor it doesn't do it all the time. Help on this would be most appriciated.

Car has done 76k on a '98 S reg.

Title: Re: 3.0 v6
Post by: ians on 16 May 2008, 11:15:34

worth doing a paperclip test to confirm no fault codes are there.

Title: Re: 3.0 v6
Post by: mega3.0v6 on 16 May 2008, 11:23:01

I have had it plugged into tech2 and no faults found and the vauxhall guy said nothing will show up if the engine management light doesn't come on.

Title: Re: 3.0 v6
Post by: bappy on 16 May 2008, 12:30:50

Got any tappet noise?

Mine was running if started from hot (cleared up after a minute) when the tappets were rattling. I changed the oil and the tappet noise and lumpyness stopped 200 miles later. might just be a coincidence tho.

Title: Re: 3.0 v6
Post by: TheBoy on 16 May 2008, 20:59:16

If no fault codes (and you can check with paperclip, cheaper than tech2 ;)), suspect HT issues...

Title: Re: 3.0 v6
Post by: mega3.0v6 on 16 May 2008, 23:59:44

Didn't pay for my tech2 (good mate of mine) changed HT leads and plugs.

Title: Re: 3.0 v6
Post by: Ian_D on 17 May 2008, 00:29:31

Could be the coil pack then. Dont think there easy to get to either on the V6!  :(

Title: Re: 3.0 v6
Post by: shanjon on 17 May 2008, 01:30:45

i had this before, i changed the plugs and leads and it still did it (now the bad news it was the coil pack , and they are not an easy job on the v6)

Title: Re: 3.0 v6
Post by: perfferle on 17 May 2008, 09:43:17

I replaced my coil pack/Dis pack last night and found the easiest method was to also remove plenum and fuel injector housing - was not a bad job.

Title: Re: 3.0 v6
Post by: mega3.0v6 on 17 May 2008, 09:56:33

silly question i got a 3 month old coil pack that i removed from my vectra 2.5 v6 would this fit and work on my 3.0.

Title: Re: 3.0 v6
Post by: TheBoy on 17 May 2008, 11:35:29

Quote

silly question i got a 3 month old coil pack that i removed from my vectra 2.5 v6 would this fit and work on my 3.0.

3 different types, but as long as same mounting and same plug, it will work

Title: Re: 3.0 v6
Post by: mega3.0v6 on 17 May 2008, 12:01:35

i'll give it ago.