Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: Jimbob on 07 July 2008, 08:27:58

Title: Side Airbag help
Post by: Jimbob on 07 July 2008, 08:27:58

My driver side airnag resistance high error is back.

Fixed it briefly twice now, after demonstation on twiddling the connector at fault by Mr DTM.

Obviosuly aint quite doing the job, so gonna take the connector off and clean it.

What should I do?  guessing battery disconnect, leave it 10 mins then play to my hearts content?

Any special procedures to removing airbag connectors, they look a little unusual.

Title: Re: Side Airbag help
Post by: Elite Pete on 07 July 2008, 08:33:19

Theres a T shaped clip you have to remove before the connection will pull apart.

Title: Re: Side Airbag help
Post by: TheBoy on 07 July 2008, 09:53:27

I'm sure there is a TIS article about soldering the connections. Not got TIS handy though

Title: Re: Side Airbag help
Post by: Jimbob on 07 July 2008, 09:58:40

Quote

I'm sure there is a TIS article about soldering the connections. Not got TIS handy though

There is, but thats at the seat base connections, which when wiggled while wathcing on tech2, weren't the issue, its the connector in the seat back thats playing silly buggers  >:(

Title: Re: Side Airbag help
Post by: TheBoy on 07 July 2008, 12:05:02

Quote

Quote

I'm sure there is a TIS article about soldering the connections. Not got TIS handy though

There is, but thats at the seat base connections, which when wiggled while wathcing on tech2, weren't the issue, its the connector in the seat back thats playing silly buggers  >:(

Thought there was one for seat squib as well  :-/

Title: Re: Side Airbag help
Post by: Jimbob on 07 July 2008, 12:18:19

maybe, I'll recheck

Title: Re: Side Airbag help
Post by: Jimbob on 07 July 2008, 18:54:41

Well, battery disconnected, connector on and off a few times, all back together and no airbag light, will see how it goes.

Fingers crossed!