Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: sprucey on 06 September 2008, 16:48:24

Title: omega 2.5 v6 induction kit
Post by: sprucey on 06 September 2008, 16:48:24
hi i was wonderin if sum1 could help me with a question i was goin to install a viper induction on my 2.5 v6 but then i got told i couldnt as he makes the car over rev then die wen u pull up to junctions so can sum1 please help
Title: Re: omega 2.5 v6 induction kit
Post by: serek on 06 September 2008, 17:16:24
if you will install kits on your car you dont get any more power  just more noise over 3500 rev
but if you install induktions kits, sports exhaustes and remap then poss get up to 10-15 % more power and rev go bet up
Title: Re: omega 2.5 v6 induction kit
Post by: philhoward on 06 September 2008, 17:21:32
I think this topic has been raised many times before - virtually all the "induction kits" require the filter element (be it foam or cotton) to be oiled.  This oil then gets dragged through the air flow meter (MAF), cooking onto the hot wire element.  Before you know it, you're looking at terrible running problems, management lights and a bill for a new MAF sensor - and a recommendation to put the original filter arrangement back on.

If you equate more noise with more power - go ahead.  There's virtually no restriction in the standard setup so i fail to see how you can gain anything?  Most of the "+10bhp" gains are over a DIRTY standard air filter; a standard clean one might not "look as good", but will perform better in 99% of cases.
Title: Re: omega 2.5 v6 induction kit
Post by: sprucey on 06 September 2008, 17:21:38
hi thank you for the advice so it's safe to install then as i dont wanna screw the car up
Title: Re: omega 2.5 v6 induction kit
Post by: sophos9 on 06 September 2008, 17:22:56
Dont bother adding this, will cause more problems and will give almost zero benefit....

You have been warned  :y
Title: Re: omega 2.5 v6 induction kit
Post by: markey mark on 06 September 2008, 17:27:53
Quote
hi thank you for the advice so it's safe to install then as i dont wanna screw the car up

yes mate put it on sounds ace and with it being the viper wont get any probs with heat !! :y
Title: Re: omega 2.5 v6 induction kit
Post by: hotel21 on 06 September 2008, 17:36:08
[split] [link=http://www.omegaowners.com/forum/YaBB.pl?num=1220718628][splithere][/link][splithere_end]
Title: Re: omega 2.5 v6 induction kit
Post by: tmx on 06 September 2008, 20:34:53
dont bother you will loose power !

the omegas standard air intake is ample!
Title: Re: omega 2.5 v6 induction kit
Post by: feeutfo on 06 September 2008, 23:51:39
post up a link if you would be so kind, would not mind a look, but chances are it wont improve over stock. Ill bet you... Ooh... a pound?
Title: Re: omega 2.5 v6 induction kit
Post by: feeutfo on 07 September 2008, 00:22:16
ps
there is a rolling road day in the meeting section, bring one along and maybe do some back to back tests, ill have a pound on the stock set up...