Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: The Doctor on 01 October 2008, 22:00:58
-
Happened recently after using wipers on full speed during some very heavy rain. Got home and turned the ignition off and the wipers were half way accross the window. Their limits are correct, ie the full motion sweep is still perfect, but they always return the the incorrect position.
I've had to raise the seat to see safely past them.
Anyone know of a limit microswitch that can be adjusted, or a reset procedure for them?
-
the motor could have slipped, make sure its still seated ok underneath the scuttle.
-
Take the whole mechanism out. From the motor to the actuall mechaism is a plate that converts the rotary motion of the motor to the back & forward motion of the arms. There is an M8 nut that's come lose & needs aligning back up again. there are 2 v's that need to point to each other >< You'll see when you take it all out. :y
-
Happened recently after using wipers on full speed during some very heavy rain. Got home and turned the ignition off and the wipers were half way accross the window. Their limits are correct, ie the full motion sweep is still perfect, but they always return the the incorrect position.
I've had to raise the seat to see safely past them.
Anyone know of a limit microswitch that can be adjusted, or a reset procedure for them?
ive had this before..........nut had come loose on motor....check yours :y
-
thanks for the tips.. will investigate saturday morning!
-
With thanks, all is sorted.
to clarify, upon removing all 4 mounting screws and withdrawing the motor assembly sideways towards the drivers side wing, a 2" long link arm attaches to the motor gear drive, the 13mm nut had worked a little loose and under strain occasionally the little link arm slipped position. Where the link arm passes the rest of the bracket there are two V shapes, the arm should be loosened, and repositioned between those two marks. Tighten and refit, all perfect.
-
I know this is an OLD post, but has anyone got any pictures of what i'm looking for - as I have gone through two motors & linkage, and now the current one has done exactly the same thing, I removed and fitted myself, and been working fine for 3 months, and now exactly the same, stops half way up windscreen - doesn't return to the bottom.
Regards
-
I know this is an OLD post, but has anyone got any pictures of what i'm looking for - as I have gone through two motors & linkage, and now the current one has done exactly the same thing, I removed and fitted myself, and been working fine for 3 months, and now exactly the same, stops half way up windscreen - doesn't return to the bottom.
Regards
http://www.omegaowners.com/forum/index.php?topic=117001.0
and if your current linkage is knackered send me a PM ;)
-
I know this is an OLD post, but has anyone got any pictures of what i'm looking for - as I have gone through two motors & linkage, and now the current one has done exactly the same thing, I removed and fitted myself, and been working fine for 3 months, and now exactly the same, stops half way up windscreen - doesn't return to the bottom.
Regards
This one is from an Astra, but the principle is the same.
(http://i84.photobucket.com/albums/k17/Tiff4327/S73F1936.jpg) The 13 mm nut that's holding the arm in position has come loose. On the casting is a mark that looks like 'A' .... there's another on the other side but pointing towards us. the arm should park between the two, but yours is parking somewhere else because the nut isn't holding the arm on its spindle.
You need to remove the nut, position the arm correctly & use a little thread lock on the nut when you replace it (or use a Nylock if you have one)
-
I just knew Rob would beat me! ;D ;D ;D ;D ;D (I got the picture in first though ;) but didn't know there was a guide)
-
My "how to" link has been resting in the "test" section since August last year Andy ;D
-
My "how to" link has been resting in the "test" section since August last year Andy ;D
;D ;D ;D ;D
I first did this job (11/12/13) years ago when SWMBO came home in the rain with the wipers parked halfway across the screen of my Senator! So it's a problem not just common to Omegas. ;)
-
Basically same linkage/same problem
-
Basically same linkage/same problem
Neither of my Astras did it though ..... same-ish linkage too ;)
-
I know this is an OLD post, but has anyone got any pictures of what i'm looking for - as I have gone through two motors & linkage, and now the current one has done exactly the same thing, I removed and fitted myself, and been working fine for 3 months, and now exactly the same, stops half way up windscreen - doesn't return to the bottom.
Regards
http://www.omegaowners.com/forum/index.php?topic=117001.0
and if your current linkage is knackered send me a PM ;)
Had the same issue on the Estate - followed Robs pics in his link - fixed and ok since.
Didn't remove mine - just wipers off, scuttle off, align and tighten nut, reassemble - pics a great help - 20 - 30 minute job max :y