Omega Owners Forum
		Omega Help Area => Omega General Help => Topic started by: kevpuk on 11 October 2008, 12:42:06
		
			
			- 
				My Omega came with a protusion on the passenger side of the centre console, with a phone holder on it....and a power cable snakes out from the bottom of the centre console (where dashboard part meets floor part)......any ideas on how to tidily remove this - I am assuming it is a relatively common fitment, seems to match the rest of the trim etc.
 
 Just don't want to be pulling bits I shouldn't whilst looking for how it is held together, assuming someone here has already done similar ?
- 
				Can you post a picture? Would help to identify what's what!
			
- 
				Here you go....shamelessley snaffled from the Autotrader ad that alerted me to the car ;)
 
 (http://build-u-like.mine.nu/sales/interior)
- 
				SWMBO's Asra had a similar phone holder. IIRC it had a plastic 'blade' that slotted in between the 'wooden' dash and the grey console. The belt & brace bit was a sticky pad onto where you have the 'wood' too.
			
- 
				Have a look here if you need to remove front panel :)
 http://www.omegaowners.com/forum/YaBB.pl?num=1152745540
- 
				Have a look here if you need to remove front panel :)
 http://www.omegaowners.com/forum/YaBB.pl?num=1152745540
 Definitely it has the 'blade' between fake wood and grey plastic.....just not so sure on how the other end attaches.....down by/behind the glovebox
- 
				In mine, if I look up under the glovebox to the right I can see the "telematics" box ( if that`s what it`s called :D) You should be able to trace the connection from there :)
			
- 
				Hey Kev
 
 If you are able to remove it without damaging it and were going to bin it, can I have it? :-?
- 
				Sure, assuming it all comes off in good nick etc - will let you know :)