Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Jay w on 22 November 2008, 17:39:51
-
Been doing a lot of work on the omega today.
Full service on the petrol side, LPG fuel filter changed and check the settings.
Before i plugged the lappy in i downloaded the latest software, as part of this i noticed that there was a notice about the firmware.
my ecu has 1.9.25 firmware, there was a update to 1.9.27, so after setting the fuel gauge up and taking the car for a spin to check everything out i decided to do the upgrade....
Started the process and about 10 seconds in the laptop lost contact with the ECU, after that it all went wrong......the LPG system went dead....nothing at all, even the gauge was dead.
The ECU has power, but none of the sensors or injectors have power to them, i have checked all the fuses i can see and they are all good......
now i have heard of ECU's going bang when S/W updates are done on them, but before i write it off and speak to Telio does anyone have any other ideas?
Cheers
-
Not a lot of help but mine took the upgrade with no issues at all :y :y
Check all your connections thoroughly ::) ::)
-
If it cut off half way through, may be corrupt? :-/
-
Not a lot of help but mine took the upgrade with no issues at all :y :y
Check all your connections thoroughly ::) ::)
Lazy, do you have Telios details? if so could you PM them to me please?
i have been all over the ecu connector and the OBD and USB connectors, all of that was in place very snugly,
-
If it cut off half way through, may be corrupt? :-/
didn't even get to halfway, at 10% it all went a bit pete tong :-/ and stopped working from there...
I have disconnected the battery, and even looked to see if there was a backup of the 1.9.25 S/W but alas no
-
If it cut off half way through, may be corrupt? :-/
didn't even get to halfway, at 10% it all went a bit pete tong :-/ and stopped working from there...
I have disconnected the battery, and even looked to see if there was a backup of the 1.9.25 S/W but alas no
If it cut off 10% through flashing, that may be enough.
I recall my manual did say something about it being game over, it if was cut off during this process :-/
-
You will need to speak to the supplier as James said knackered
-
oh bugger.....
Jeremy is somewhat difficult to get hold of at times, hence wanting to get hold of Telio
-
oh bugger.....
Jeremy is somewhat difficult to get hold of at times, hence wanting to get hold of Telio
PM sent with details :y
-
oh bugger.....
Jeremy is somewhat difficult to get hold of at times, hence wanting to get hold of Telio
Yep... Details sent :y :y
-
What a bummer Jay >:(
Hope you get it sorted soon matey :y
-
thanks guys,
I am going to drop Telio an email over the weekend and explain what's happened, hopefully we can get this sorted fairly swiflty :D
-
thanks guys,
I am going to drop Telio an email over the weekend and explain what's happened, hopefully we can get this sorted fairly swiflty :D
Good luck matey, hope you get it sorted quickly :y
-
Definitely give him a call on Monday though... He can be a little slow responding to emails!
He really knows his stuff and is desperate to help solve any issues :y :y :y
-
Damn. >:(
IIRC, there is a way to reset the ECU to a boot loader where you can do another firmware upload, if it had previously failed. Not sure where I read that though. :-/
I think I'm using 27 on mine (came out about May time IIRC?) so the firmware should be good.
Kevin