Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: egg on 15 February 2009, 21:15:07
-
I think i need to renew the thermostat on my 2.5 diesel. Temp needle doesn't really move off the bottom of the gauge. Even in traffic it doesn't move. Even when towing my van it doesn't move very far.
Has anyone changed 1 before? It is an easy job? How much is a new 1?
Any advice would be great. ;)
-
http://cgi.ebay.co.uk/Vauxhall-Thermostat-Seal-90541659-Omega-2-5Diesel_W0QQitemZ190280222009
not sure on fitting
-
I think i need to renew the thermostat on my 2.5 diesel. Temp needle doesn't really move off the bottom of the gauge. Even in traffic it doesn't move. Even when towing my van it doesn't move very far.
Has anyone changed 1 before? It is an easy job? How much is a new 1?
Any advice would be great. ;)
I've covered it a few times lately, see if a search will find it :)
-
No mate can't find it.
-
OK, black turbo diesel plastics off.
That stupid, gay, pointless, gay stupid bloody fan off (left hand thread) - god knows what the pillock at BMW was smoking that day. Remove plastic cowling around it.
Undo bottom hose from stat housing.
3 10mm bolts hold stat housing in place.
Refit its reverse, its also a good time to drain rad and block (lol - before you start!), to ensure decent antifreeze mix.
-
OK, black turbo diesel plastics off.
That stupid, gay, pointless, gay stupid bloody fan off (left hand thread) - god knows what the pillock at BMW was smoking that day. Remove plastic cowling around it.
Undo bottom hose from stat housing.
3 10mm bolts hold stat housing in place.
Refit its reverse, its also a good time to drain rad and block (lol - before you start!), to ensure decent antifreeze mix.
Does it require a gasket?
Mick
-
only a o ring part no 90509113 but if u buy that one off ebay u get the o ring
-
Straightforward jobbie - around half an hour.