Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: vauxfan2k on 11 February 2009, 18:13:29
-
in the middle of converting the cdx to self levelling suspension, my elite has had it removed at some point before I got it .
I need a diagram or photo of the correct routing for the small pipes that run from the pump to each shock.
can anyone help?
thanks
-
in the middle of converting the cdx to self levelling suspension, my elite has had it removed at some point before I got it .
I need a diagram or photo of the correct routing for the small pipes that run from the pump to each shock.
can anyone help?
thanks
I'll try and get a pic tomorrow if I remember ::) ::) ::)
Off the top of my head it runs down the drivers side with the fuel lines and then into a T piece above the rear suspension where it splits to go to either side
-
that would be great, ta
I seem to be missing all the clips to hold the pipes in place so will have to get them before I can finish.
cheers
-
Right... I forgot to take some pictures but the pipes run alongside the fuel lines ::) ::)
I'll get some when it's in the air for the MOT re-test next week :y :y
-
Here you go... Not very good I'm afraid as I only had the mobile on me and a couple of minutes on the ramp :y :y :y
T Piece near fuel filter
(http://farm4.static.flickr.com/3216/3292956067_162f6eee20.jpg)
Pipe run
(http://farm4.static.flickr.com/3344/3293778720_61a0eded43.jpg)
Pipes through outriggers
(http://farm4.static.flickr.com/3342/3292955157_2914ea9a79.jpg)
Hope this helps a little :y :y :y