Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: The Barge Captain on 29 March 2009, 21:47:51

Title: 4 pot cam cover question
Post by: The Barge Captain on 29 March 2009, 21:47:51
Quicky on behalf of the old man about his 2.0.
Plug wells are full of oil, so i'm assuming the breathers are blocked and oil is blowing out of the cam cover joint.
Have recomended an oil change and breather clean out, however, is there a gasket to be replaced or is it an instant gasket type of joint that needs cleaning up and re-gunging?
Thanks.
Title: Re: 4 pot cam cover question
Post by: alexandjen on 29 March 2009, 21:51:33
Quote
Quicky on behalf of the old man about his 2.0.
Plug wells are full of oil, so i'm assuming the breathers are blocked and oil is blowing out of the cam cover joint.
Have recomended an oil change and breather clean out, however, is there a gasket to be replaced or is it an instant gasket type of joint that needs cleaning up and re-gunging?
Thanks.

No there is a rubber gasket and o rings to replace , there is a guide in the maint section :y
Title: Re: 4 pot cam cover question
Post by: tony2 on 29 March 2009, 21:52:53
Quote
Quicky on behalf of the old man about his 2.0.
Plug wells are full of oil, so i'm assuming the breathers are blocked and oil is blowing out of the cam cover joint.
Have recomended an oil change and breather clean out, however, is there a gasket to be replaced or is it an instant gasket type of joint that needs cleaning up and re-gunging?
Thanks.
Title: Re: 4 pot cam cover question
Post by: tunnie on 30 March 2009, 08:08:02
check out my lovely guide in the maint section ;) its all there with gm part numbers :)