Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: money spinner on 09 April 2009, 16:08:59
-
For some strange reason, the passenger (electric) seat on my 51 plate Omega CDX 2.6 Auto is stuck at full height position?
When the height adjust switch is pressed (down) all you hear is a click, and no movement of the seat what so ever?
As I have not driven my car sitting from the passenger side before, I have no idea how long it has been like this? I only noticed it the other day when I was doing a bit of valeting sitting on the passenger front seat and as it was set too high for my relaxed lounge driving style, I went to lower it and nothing happened.
Any ideas as what could be wrong? I have looked under the seat at the threaded long bar that connects to the motor whilst pressing the switch. When the switch is pressed, you can see about a mm or two movement of the threaded bolt, and then you hear a single click from the motor area. That's it!
If anyone can help I would be grateful!!
Kent.
-
hi mate my motors were stuck when i had my first i had to put a small mole grips on the shaft and turned it to help it come back down . they get jamed when at full hight . but it will come back down with help when you turn the threaded bar / but dont put grips on the thread put it on the shaft . hope this helps you mate
-
This has been covered on here before, the seat sticks at either top or bottom end of travel, can be freed by a socket on the nut on the end of the threaded screw as viewed from behind the seat, once freed apply some grease to the end of the thread and avoid furthest ends of the travel if possible
-
Thanks for the advice, I will be out with a pair of grips later today and give it a wiggle!!
-
Thanks for the advice, I will be out with a pair of grips later today and give it a wiggle!!
you need to press button aswell to free motor
-
http://www.omegaowners.com/forum/YaBB.pl?num=1163236766
Found it...