Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: OMEGA16V on 14 April 2009, 20:33:24
-
Hi everyone the engine warning light came on today and the car is running ok just seems a small bit louder and more vibrations coming from the front end? possible its not running on four cylinders or coil pack? any help appreciated thanks
-
Read the fault codes, have a little look on here for the paper clip test
-
Here's the codes
http://www.omegaowners.com/forum/YaBB.pl?num=1206569943
-
thanks omega_man but how do i run the fault codes? i know with some engines theres a crossover you can do with the diagnostics but im new to omegas :)
-
Look here http://www.omegaowners.com/forum/YaBB.pl?num=1189022687 :y
-
You need to cross connections on the diagnostic connector with the ignition off and the light will flash the codes out. There is a picture on here somewhere of which ones to cross but i'm fairly sure it's the 3rd and 5th up. But check first :y
Edit:Must type and post links faster :D
-
ok just done it thenow and got two faults, the first was 1 flash followed by 2 flashes? the second fault was 7 flashes followed by 1?
-
12 is the start of the sequence. 71 is the air temp. sensor. Any odd temp readings on your dash display :question
-
no rob just the engine warning light is all? where is the air temp sensor located?
-
Its a 2 pin item mounted in the air duct between the air fliter (large box front left of the engine bay) and the throttle body.
There is also a 4 pin connector which is the MAF, you want the 2 pin one :y
Check the wiring and make sure its connected ok
-
got sorted just the air flow meter was loose thanks dudes :y