Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: SJKOO01 on 18 May 2009, 18:10:14

Title: Help needed please-Auto Trans giving P1625 code ?
Post by: SJKOO01 on 18 May 2009, 18:10:14
Hi all.

In my other thread I originally thought I had an engine problem as my engine light came on, on the dash;


http://www.omegaowners.com/forum/YaBB.pl?num=1242505053/0#0


However, today going to work & coming home the light didn't come on.
But bought myself a code reader anyhow. There nothing showing in the engine codes, but out of curiosity I thought I would check the Auto trans codes to see if there was anything in there;

P1625 has shown up. Does anyone have an idea of what the problem may be in the transmission, as there's no noticeable problems at the moment - I'm totally confused by the engine light showing on the dash, going off, then finding I've a transmission problem ??????  :o ,

Help please as need a car to get about in very much !

M :-[
Title: Re: Help needed please-Auto Trans giving P1625 code ?
Post by: TheBoy on 18 May 2009, 18:34:52
Lots of measuring to be done, looks to be related around Pressure Regulator, so find that on your wiring diags, and take some measurements
Title: Re: Help needed please-Auto Trans giving P1625 code ?
Post by: SJKOO01 on 18 May 2009, 18:48:03
Have to admit, I'm very much a numpty when it comes to electric on a car.
Found in my haynes manual refererance to "Solenoid - main fluid pressure control" (U10.2) in the list, is this the same thing as Pressure Regulator ?.

Now just got to find it on the tiny diagrams ?!.

Title: Re: Help needed please-Auto Trans giving P1625 code ?
Post by: SJKOO01 on 18 May 2009, 19:09:08
Regards to above, can only find something relating to solenoid - main fluid pressure control, and that looks like it maybe to do with the ECU if I'm reading the diagrams right ??.

Is there a pressure regulator actually physically fixed to the gear box that is known to be problematic at all ?.
Title: Re: Help needed please-Auto Trans giving P1625 code ?
Post by: TheBoy on 18 May 2009, 19:23:16
Sorry, had to post quickly earlier as the battery had died in the lappy.

The pressure reg will be in gearbox, so find its connector, and take some meaurements.
Title: Re: Help needed please-Auto Trans giving P1625 code ?
Post by: SJKOO01 on 18 May 2009, 19:55:00
No problems with delay, as I've been trying to find wires on wiring circuit anyway, no luck so far.

What kind of measurements am I looking for / needing to do ?.
Am I looking for something called an open circuit or looking for voltage readings.

Would you mind explaining what I need to look for, I can get a friend who understands electrics better to help out then.

Sounds like this is going to be expensive for me again though ?!.  :-[
Title: Re: Help needed please-Auto Trans giving P1625 code ?
Post by: sassanach on 19 May 2009, 22:59:29
"force motor/aka solenoid" is located in the front sump on  the steering wheel side.
Title: Re: Help needed please-Auto Trans giving P1625 code ?
Post by: SJKOO01 on 21 May 2009, 22:27:22
Thanks for advice. Will take a look this wk/end to see if I can get any readings and post them when I do.

Thanks to those who've helped with advice.

M  :)
Title: Re: Help needed please-Auto Trans giving P1625 code ?
Post by: SJKOO01 on 28 May 2009, 20:13:06
Apologies for bringing this to the front again.

Haven't managed to get the readings, as can't find a way to 'patch in' to the loom as don't know where to start ?.

Also as I'm not electrical techy, what am I looking for, readings show consistance, or readings regards to volts measurement ?.

Any advise on where to start would be greatly received thanks.

M  :)