Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Ding a Ling on 01 June 2009, 14:35:22
-
Hey Guy's, new front Wheel Bearings for my Chariot..... Vx say that i have to purchase the entire Hub Assembly at £100+each !!! Has any one got an old bearing that we can 'read' the Bearing Manufactures part number off? (crested on the side of the outer ring usually) Are they all the same? mines an '02 2*6l Estate........... Da Boy, u out there? wadda ya fink?
Waiting with very short finger nails,
Ding a Ling :'( :( :-?
-
Hey Guy's, new front Wheel Bearings for my Chariot..... Vx say that i have to purchase the entire Hub Assembly at £100+each !!! Has any one got an old bearing that we can 'read' the Bearing Manufactures part number off? (crested on the side of the outer ring usually) Are they all the same? mines an '02 2*6l Estate........... Da Boy, u out there? wadda ya fink?
Waiting with very short finger nails,
Ding a Ling :'( :( :-?
Give www.buypartsby.co.uk a call and get the Contitech pattern items (I suspect these boys also supply GM).
About 35 quid each
-
Give www.buypartsby.co.uk a call and get the Contitech pattern items (I suspect these boys also supply GM).
About 35 quid each
Fast - Accurate - Helpful............... it don't get any better than this Folk's..................
Thanks Mark (stay off the kerbs, pal) :y :D
-
Well I woke up this mornin'
Ma rear bearing was done shot
I woke up this mornin'
Will it cost me a lot?
Jus glad I got dem Oofers
To tell me what is what
(Guitar solo) 8-)
-
Hey Guy's, new front Wheel Bearings for my Chariot..... Vx say that i have to purchase the entire Hub Assembly at £100+each !!! Has any one got an old bearing that we can 'read' the Bearing Manufactures part number off? (crested on the side of the outer ring usually) Are they all the same? mines an '02 2*6l Estate........... Da Boy, u out there? wadda ya fink?
Waiting with very short finger nails,
Ding a Ling :'( :( :-?
If its excessive play nip the centre bolt up. Youll need a big breaker bar, my cheapo halfords one was visibly bending. Tip previously supplyed by Mark CTD, sorry, Dtm.
But if its buggered,the bearings can be pressed in and out. Seen it on here somewhere along with the bearing numbers, but for 35 sobs.....probably wouldnt bother.