Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Briareus on 10 June 2009, 14:51:45
-
Anyone out there that can tell me where all >:( the screws are to remove the glovebox please
-
Anyone out there that can tell me where all >:( the screws are to remove the glovebox please
Remove the four that haynes describes and there is another on the left hand side, behind the end of the dash thatthe door covers when it's shut. I do have a picture at home if you can wait till 11 o'clock :y
-
Thanks Andy - if you get a chance to send pic that would be great.
Tony
-
Thanks Andy - if you get a chance to send pic that would be great.
Tony
I will. IIRC you get to it via a hole in the end of the dash. I eneded up breaking bits of my dash when I tried to remove mine. The mini face lift have presumably got a facelift glove box with the extra 5th screw.
I took the picture & sent it to Mr Haynes, who did admitted they didn't know it was there. ::)
It'll be revised if/when they do a facelift manual ..... so don't hold your breath! ;D ;D :y :y
-
Anyone out there that can tell me where all >:( the screws are to remove the glovebox please
http://www.omegaowners.com/forum/YaBB.pl?num=1214169060 :)
-
Thanks very much for that - very helpful :y
-
Thanks very much for that - very helpful :y
Do you still want my photo? ;D ;D ;D
-
Thanks Andy but the link is brill and as usual tells the whole story :y
-
Enjoy :y
-
Thanks Andy but the link is brill and as usual tells the whole story :y
I didn't know that write up was there, it's a pity Haynes didn't use it for their book, it'd saved me a whole load of grief .... and glue, from when I broke bits! ;)
-
Believe it or not, I have just spent over an hour seeing if there was a link but couldn't find it. Its what makes this forum so good somebody somewhere knows everything you need!!! :y :y :y
-
I take it your looking for this.....
(http://i202.photobucket.com/albums/aa163/vxl_v6/PhoneConnector.jpg)
Which is usually taped up here with masking tape......
(http://i202.photobucket.com/albums/aa163/vxl_v6/PhoneInstall3.jpg)
....and when you've finished should look like this......
(http://i202.photobucket.com/albums/aa163/vxl_v6/PhoneInstall6.jpg)
-
Not only are you a master of the knowledge but you have a crystal ball too ;D ;D ;D
-
Having just put my Glovebox back in today, you now have me wondering what that plug is for and whats the box its wired to.?
I had to remove 3x silver torq screws to the top, then 2 upper screws revealed when the airbag panel is lifted. 2 lower screws. then the one in the side when air vent is removed.
still broke a clip on removal.
Fitted a permanent USB 5vDC lead and dab antenna lead into the glovebox for the Pure highway.
-
Your lucky you weren't swapping the handle, drove me insane :o
-
The first job I ever did on my Mig was replace the broken glove box handle.....took me 2 hours, ended up with sliced knuckles and well pee'd off.......Being very gentle with the new handle so I never have to do that again........!!!
:y
-
Well thanks to the wealth of knowledge on here, lead at back of glovebox found, aerial in drivers kickplate found, leads ordered and all done in under an hour :y :y :y
Special thanks to those with advice and pointing the links out ;D ;D ;D