Omega Owners Forum
		Omega Help Area => Omega General Help => Topic started by: Shane mvsex on 19 June 2009, 11:37:32
		
			
			- 
				 after having the engine cut out on me, i went to change one of my lambda sensors only to find it was finger loose half out basically...
 so i tightened it back up.. gave her a start sounds ok again....
 
 i need to give it a run see if its any better..
 
 but i did the paperclip test and its still flashing up 89 which is the sensors but now is also flashing 19 incorrect rpm signal......
 
 any ideas?
 
 should i give her a run n find out.....
 :y
 
 
 
 
- 
				Code 19 is the crank sensor.
 I had the same problem with one of my lamda sensors loose. It takes a few miles of driving before the ECU sorts itself after you fix the leak
 cbh
- 
				ok thanks
 
 so if i give it a nice run do you think it will clear up the problem??
 
 ta :y
- 
				My car ran much better after a quick blast of about 25miles.
 The code 19 is normally only fixed by changing the sensor
 cbh
- 
				The 19 is the likely reason it broke down. No amount of running/cleaning/playing will cure it, it needs replacing.
			
- 
				looks like the cars not going anywhere till i can change all 3 sensors grrr
 
 not what i wanted to find out today...
 
 cheers for the help  :y