Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: mstickler on 04 August 2009, 13:18:55
-
after charging my battery up over the weekend, put back on car & it wouldn't run, started first time on turn of key then after a few seconds just died. done a paperclip test yesterday & the code 1502 - immobiliser control unit can up is there a way to reset this or does it need to go on a reader or computer to reset it. thanks mark
-
No way to reset it.....was teh ecu light flashing when the engine stopped?
Have you opened the key up recently?
-
no haven't open key y should i
-
no ecu light not flashing just done paperclip test & came up with code 1502
-
no haven't open key y should i
Just thought you might have opened up the key & dropped the chip from inside. :y Are you using the same key as you usually use? If you have a 'favourite'/prefered key, try using that one. :y :y
-
i have used both keys & tryed to reprogram them by turn on then waiting 30 seconds & then pressing lock/ unlock one at a time still no luck
-
i have used both keys & tryed to reprogram them by turn on then waiting 30 seconds & then pressing lock/ unlock one at a time still no luck
You're only resetting the central locking by doing that. It's the chip in the key that's taliking to the alarm ECU that you need worry about.
-
how do i get over this does it need to be reset with computer or reader
-
how do i get over this does it need to be reset with computer or reader
you need someone far more experienced in the electrics/imobilisers/etc than me.
Where in the country are you? There may be very well someone local to you .... :y
-
i'm in southampton area