Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: greengoblin on 14 August 2009, 10:35:42
-
hope some one can help have no confidance in the car doing 70 mph out side lane engine decides to die management was the only light on now its doing it to regular don t under stand paper clip test do i count all flashes together and add together don t feel very bright this morning sorry for the esay thanks
-
code 19? crank sensor. :y
-
Where are you GG? Maybe someone close by can pop round and talk you through it.
-
Counting the flashes does take some practise.
have you read the guide
http://www.omegaowners.com/forum/YaBB.pl?num=1189022687
and watched the video?
http://images.omegaowners.com/images/guides/paperclip_test/paperclip.html
codes are displayed, with slight pause between digits.
so
1 11 would be 12, for start of codes,
111 1 would be 31 for no engine running
1 111111111 would be 19
1111111 1111 would be 74 if that helps at all?
without the codes, its hard to know where to start.
-
thanks mate is this an easy job just phoned vx just my luck they have 2 types for a 96 model one 79 and 51
-
If youve got it to flash then your halfway there :y
it flashes the codes each 3 times
starting with 12 ie 1 and a couple of seconds then 2
then if you have any codes ie engine out 31 so it will flah 3 times then 1 and that also three times
when it is finished telling you the codes it will give you the 12 again
It is not hard but can be confusing at times. hope this helps a bit :y
-
thanks mate is this an easy job just phoned vx just my luck they have 2 types for a 96 model one 79 and 51
DONT go changing parts until you confirm thats at fault.
it may be fine, and youve wasted your monet
it may be faulty off the shelf, and then mask the problem you are trying to fix.
It may be Crank sensor, but these dont often put the management light on, so please please check for codes 1st :y
-
I thought the EML did usually come on...for the other spurious codes crank sensor failure throws out lol
-
I thought the EML did usually come on...for the other spurious codes crank sensor failure throws out lol
ive certainly seen totally silent failures :y so looks like it can go either way.
-
thanks mate is this an easy job just phoned vx just my luck they have 2 types for a 96 model one 79 and 51
DONT go changing parts until you confirm thats at fault.
it may be fine, and youve wasted your monet
it may be faulty off the shelf, and then mask the problem you are trying to fix.
It may be Crank sensor, but these dont often put the management light on, so please please check for codes 1st :y
As Jimbob says, don't replace parts until you do the paperclip clip test.