Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Kaycee on 10 September 2009, 16:55:49
-
Hi guys
my 2002 3.2 Elite is not Locking correctly
yesterday unlocked car and all buttons came up except drivers tried again and it came up very slugishly .
Today would not come up at all but i had this problem last winter put a bit of wd40 on it thru the screw holes and was ok . Now its given up all together the card looks like it will come off ok my question is:=
could i change the solenoid with out taking out all the lock mechanism and is it visible on removal of the card i await your knowledgable replies
Robert
-
Once door card removed its just visible & removavble, I have just replaced the solenoid on my drivers door, may have second hand one for sale if you need one think its will fit later models as there are a cple solenoids just different connections i beleive, need the part number off it to be sure. :y
There's a couple of how toos here one for prefacelift other later model
http://www.omegaowners.com/forum/YaBB.pl?num=1177492197
http://www.omegaowners.com/forum/YaBB.pl?num=1152953579
And lock replacement... http://www.omegaowners.com/forum/YaBB.pl?num=1175610013
-
Kaycee, I've got a drivers solonoid off a 2001 sitting here if you need it ;) :y
-
Hi new 2 all this, but I have had the same problem, it was a plactic clip on the arm they were out cost 10p new its cos the driver door has more use opening and closein it connects to the door locking system slaming the doors dont help. :)
-
That be great wellhung pm sent
-
That be great wellhung pm sent
Stop adding letters to my name ;D ;D ;D
-
Had to laugh mate its welung i just didnt read it right please accept my apolagy
Robert
-
Thanks welung for the info etc pm sent
-
I finally got round to changing the drivers door solonoid with the excellent advice and help from welung was pretty easy really only problem was the wiring plug to the solonoid i could not compress the clips because of the limited room however i slacked off the lock screws and used a screwdriver to prise up the clip on the door side and got it of was a bit fiddly getting it into position but went in ok only thing was the wiring loom plug went in very easy too easy i thought but it was clipped in so all ok took about an hour start to finish
Thanks to all for the advice and special thanks to welung you are stars
Robert
-
i've got the same problem! any links to where i can get a solonoid/motor? thanks
-
i bet welung will have some