Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: geoff on 13 October 2009, 10:31:08

Title: door adjustment
Post by: geoff on 13 October 2009, 10:31:08

is it possible to adjust door gaps for forward and back or up and down can't see any adjustment if i can :y :y :y

Title: Re: door adjustment
Post by: Marks DTM Calib on 13 October 2009, 10:32:13

Forward and back, no, up and down, to some extent yes by adjusting the catch plate on the B or C pillar's.

Do check the hinge pins for wear though

Title: Re: door adjustment
Post by: geoff on 13 October 2009, 10:35:41

ok just seeems my drivers door seems further forward than the passenger side could this be normal or pin wear  :y :y :y

Title: Re: door adjustment
Post by: unlucky alf on 13 October 2009, 10:39:32

is that on the door shut side or the front edge?, might be the front wing thats too far back :y

Title: Re: door adjustment
Post by: geoff on 13 October 2009, 10:40:25

door shut side :y :y

Title: Re: door adjustment
Post by: unlucky alf on 13 October 2009, 10:42:48

sounds like the hinges have taken a whack in the past, is there any sign that its a replacement door. :-/

Title: Re: door adjustment
Post by: geoff on 13 October 2009, 10:45:58

when brother in law bought car 5 years ago was cat c but garage only replaced wing

Title: Re: door adjustment
Post by: unlucky alf on 13 October 2009, 10:57:31

might be worth trying to take some measurements, i had this on a car some time ago & found it was the hinge sections on the post were bent,  :y