Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: ajn on 27 October 2009, 19:21:47
-
hello ive replaced the heater bypass valve today but cant see where the thin pipe on top of the h.b.v is ment to go any ideas cheers ajn
-
hello ive replaced the heater bypass valve today but cant see where the thin pipe on top of the h.b.v is ment to go any ideas cheers ajn
do you mean the little vac pipe ontop of the valve? this comes from the bulkhead near where the matrix pipes go through, thin black pipe with a rubber elbow that goes on the top of the valve. :y
-
At the HBV end or the other end?
-
At the HBV end or the other end?
thanks for the replys ive got a rubber elbow off the hbv and about 4 inch thin pipe nothing on the end and cant see where it goes
-
At the HBV end or the other end?
thanks for the replys ive got a rubber elbow off the hbv and about 4 inch thin pipe nothing on the end and cant see where it goes
if i remember right, this should plug into the bulkhead between the matrix pipes. should be a rubber connector there. ::)
-
ok thanks lads ill have a look tommorow not an enjoyable job the hbv :y
-
ok thanks lads ill have a look tommorow not an enjoyable job the hbv :y
not really, plenty of finger cutting & swearing :D
-
hello ive replaced the heater bypass valve today but cant see where the thin pipe on top of the h.b.v is ment to go any ideas cheers ajn
http://www.omegaowners.com/forum/YaBB.pl?num=1152565204 :y
-
At the HBV end or the other end?
thanks for the replys ive got a rubber elbow off the hbv and about 4 inch thin pipe nothing on the end and cant see where it goes
if i remember right, this should plug into the bulkhead between the matrix pipes. should be a rubber connector there. ::)
:ysorted thanks for all replys ajn
-
well done :y